For all those 
The zip includes a PDF (manual) and the drivers.
http://www.filesend.net/download.php?f=90df7c1b08282fa678929d510ff78bac
OR
http://www.filedropper.com/atomcnc
OR
For all those
The zip includes a PDF (manual) and the drivers.
http://www.filesend.net/download.php?f=90df7c1b08282fa678929d510ff78bac
OR
http://www.filedropper.com/atomcnc
OR
Thanks for this, but the driver doesn’t install in Windows XP Tablet PC Edition (fails w/ an error message) and when I try to plug it into my daughter’s MacBook, Universal-G-Code-Sender by Will Winder doesn’t see it, listing only Bluetooth devices.
Is there some alternate driver I could install into Windows XP to use this?
If not, what environment do I need to make this work?
Ill create a custom driver for you. Not sure why it didnt work. I havent had a issue with any of the other AtomCNCs like that.
This should work for you and everyone else.
Windows XP,7,Vista (32bit & 64bit)
MAC (no drivers)
DOWNLOAD
Didn’t work.
Cannot Complete the Device Driver Installation Wizard
Errors were encountered while installing the software for your devices.
See the Status column for more details.
Sometimes it helps to run this wizard again. (No, it doesn’t) If that doesn’t work, contact your device vendor.
So, I’m here again.
It doesn’t work on my daughter’s MacBook either — shows up in the USB device tree, but universal gcode sender doesn’t see it — is there some other program to try?
What do I need to do to make this work or get a working machine?
Thought to try uninstalling, then plugging and un-plugging the device, then letting the new hardware wizard try w/ your archive — running the “Hello World” Shapeoko file in the air now.
Thanks!
Glad to hear that! You can discard the email i sent you then