DipDuino-SAMD21

Hey everyone. Ive been busy working a new job and been kind of sick lately. So i havent had much time to do any physical work but i do have a new board. Its based on my DipDuino but using the SAMD21 instead. This is a beautiful little PCB with tons of power in a nice small form factor.

The MCU of choice here is the ATSAMD21G18 which is a 32-Bit ARM Cortex M0+. The PCB operates on 3.3v and can be powered and programmed via USB Cable. You can also power with USB pin on the header but please dont do both at the same time as there is no real protection for your USB port.

The SAMD21G18 runs at 48MHz and has 256KB of FLASH and 32KB of SRAM. Its a great part. The Arduino Zero uses the same MCU and this means that i will also preprogram this to run as an Arduino Zero for out of the box programming. No need for a debugger.

Here is a render. The PCB is 71.63mm x 12.06mm [2.82in x 0.47in] … No actual PCB made or tested but maybe soon.

Published by atomsoft

Starting a small company. Trying to build it from ground up. Only 2 employees so far. Nothing serious yet but soon!

One thought on “DipDuino-SAMD21

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

<span>%d</span> bloggers like this: